USING JUICE EXTRACTOR
The appliance will only function if all parts have been properly assembled
and the lid has been properly locked in place with the locking arm.
1
Place the juice collector onto the
motor unit, and put the filter into the
juice collector. Make sure the filter is
fitted securely onto the drive shaft.
3
Place the pulp container under the
appliance by tilting it fomard slightly.
5
0
1
2
Switch on by turning the control
knob to select setting 1 (low speed),
2 (normal speed) or P (pulse) to
start.
2
Place the lid on the unit, and lift the
locking arm upwards to lock in
position on either side of the lid.
4
Silde the pusher into the feeding tube
by aligning the groove in the pusher
with the small protrusion on the
inside of the feeding tube.
6
Put the pre-cut pieces into the
feeding tube and gently press them
down with the pusher towards the
rotating filter. Make sure the juice jug
is placed under the juice spout before
making juice.
4 PREPARING FOR USE
To Next Page
Loading...