Kolibri KCS-2000 - Page 8

11
To use the coin tube attachments, perform the following steps:
1. Remove the coin tray(s) for the denomination coins that will be using coin tubes.
2. Insert the appropriate preformed paper wrapper completely into the tube with the
crimped side on the bottom.
3. Ensure that the wrapper shape is round, and the upper tip is not bent over so coins
can easily fall into the tubes.
4. Secure the coin tubes to the KCS-2000 by gently sliding each tube into the proper slot
in the base of the machine.
5. Set coin roll batch quantities (see section 2.4) for each coin denomination by
pressing and holding the “+” button for approximately three seconds until “L” is
shown in the display. This programs each coin denomination for standard bank
coin roll sizes.
6. Load coins into the coin hopper and press the “START/STOP” button. The KCS-2000
will automatically dispense the correct number of coins into each coin tube.
7. When the number of dispensed coins equals the batch quantity for any
denomination, the KCS-2000 will stop and display a message on the control panel.
For example, after the rst batch of 50 pennies has been counted, the front panel
will display:
1c 50 (quantity reporting)
or
1c 0.50 (value reporting)
Note: When operating in batch mode, the KCS-2000 will keep a running total for each
denomination coin. For example, after four batches of 50 pennies have been dispensed,
the KCS-2000 will stop and display:
1c 200 (quantity reporting)
or
1c 2.00 (value reporting)
8. Remove the full coin tube from the KCS-2000 and slide out the paper wrapper
containing the coins. Crimp the open end of the wrapper. Insert and empty wrapper in
the coin tube and reinstall the coin tube.
9. Press the “START/STOP” button to continue batching.
12
3. Attach the coin tubes to the KCS-2000 by gently sliding each tube into the proper slot
in the base of the machine as shown in Figures 2 and 3.
Figure 2 - Installing coin tube Figure 3 - Coin tube in proper position
Figure 4 - US model Figure 5 - Canadian model
Coin tube locations for each country varies. Use coin denomination labels to help
you place the coin tubes. Coin tubes should be placed exactly underneath the coin
denomination label.
(Set up for other countries may vary)
8
7
4
3
2
5
6
8
1
7
4
3
2
5
6