KOLINK Unity Peak ARGB - Page 2

UNITY PEAK ARGB
ARGB INSTALLATION MANUAL
Connect up to 6 ARGB devices to the ARGB fan hub controller. 4 fans are pre-installed. Connect additional ARGB devices to the free headers. Connect the 5V
ARGB MB sync. cable to the mainboard 5V ARGB header to control the lighting via the mainboard.
Note: The controller only supports 5V ARGB (5V/Data/-/GND) devices. Please check the manual of your mainboard for supported connectors.
www.kolink.eu Page 1/2
ARGB1 ARGB2 ARGB3 ARGB4 ARGB5 ARGB6
Fan
5V ARGB Cable
5V ARGB MB-Sync.Cable:
→ Connect to MB
Mainboard
5V ARGB Header
ARGB Connection