OM2220 8/11 Safety - Section 22
Page 22-9
PRODUCT IDENTIFICATION PLATE
A product identification plate is located on the frame in
front of the right side front wheel. It shows the Truck
Model Number, Maximum GVW, and Product
Identification Number (PIN).
The Product Identification Number (PIN) consists of a
total of 19 characters. The first and last characters are
tamper preventive symbols (*). The remaining 17
alpha/numeric characters are used to identify the
following five characteristics of the machine:
WMC - Character positions 1, 2 and 3 identify the
Worldwide Manufacturer Code (WMC). The WMC
designates the manufacturer of the product. Komatsu
brand products are identified with the letters KMT.
MDS - Character positions 4, 5, 6, 7 and 8 identify the
Machine Descriptor Section (MDS). The MDS code
identifies general information regarding machine
specifications. The MDS is a code for the machine type
and model.
CL - Character position 9 identifies the Check Letter
(CL). The CL is used to verify the accuracy of the
individual PIN.
FC - Character positions 10 and 11 identify the Factory
Code (FC). The FC identifies the Komatsu factory in
charge of claims for the product. The FC for electric
drive trucks is 61.
SN - Character positions 12, 13, 14, 15, 16 and 17
identify the Serial Number (SN). The SN is a unique
sequential number.
To Next Page
