12. LOADING OPERATIONS
2-16
• Do not tilt the mast forward when the forks are loaded and raised.
There is danger that the load may fall and that the lift truck may tip.
• Do not travel with the mast tilted forward.
• Do not load and unload on slopes.
DO NOT TILT MAST FORWARD WHEN LOADED
• If the mast rail or forks catch in a load or on a shelf, slack in the lift chain
may be created, resulting in danger that the load may fall and the lift
truck tip.
• Always be careful that there is no slack in the chain when pulling the
forks out from a pallet or shelf.
KEEP TENSION ON CHAIN
• Do not use the lift truck for anything other than the intended use
(loading operations using the forks).
• Do not use the forks to open or close the doors of railroad cars or
warehouses.
• Do not push any other vehicle.
• Do not hook ropes or cables on the forks and use the forks to lift
loads.
• Do not use the drawbar pin for towing operations.
USE ONLY FOR INTENDED PURPOSES
• Be careful not to operate the lever by mistake. There is danger that the forks or work equipment may
cause serious injury.
• Do not operate the levers when getting off the lift truck.
LEVER OPERATION
To Next Page
Loading...
