DETAILED CONTROLS AND GAUGES OPERATION
3-18
(D): HEAT position
Set to this position when starting the engine in cold weather.
When the key is set to HEAT position (D), the preheating monitor lights up. Keep the key at the HEAT position until
the preheating monitor flashes. When the preheating monitor flashes, release the key immediately. (The flashing
will stop after approx. 10 seconds.) When the key is released, it will return to OFF position (A), so turn it immedi-
ately to START position (C) and start the engine.
Fuel Control Dial
This dial (2) adjusts the engine speed and output.
(a) Low idling (MIN): Turned fully to the left
(b) Full speed (MAX): Turned fully to the right
Cigarette Lighter
This switch (3) is used to light cigarettes. To use, push the
lighter in. After a few seconds it will spring back.
Pull out the lighter and light your cigarette.
By removing the cigarette lighter, the socket is available as a
power source for the yellow flashing lamp. Max. current is 3.5 A
(85 W).
To Next Page
Loading...
Need help?
General
