MACHINE OPERATIONS AND CONTROLS OPERATION
3-126
MACHINE INSPECTION AFTER DAILY WORK 3
1. Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check for
any leakage of oil or coolant. If any problems are found, repair them.
2. Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4. Remove any mud affixed to the undercarriage.
LOCKING 3
Always lock the following places.
(1) Door of operator's cab
Always remember to close the window.
(2) Fuel tank filler port
(3) Engine hood (3 places)
(4) Battery box cover (2 places)
(5) Left side door of the machine (2 places)
(6) Tool box side cover
(7) Hydraulic tank filler port
REMARK
Use the starting switch key to lock and unlock all these places.
To Next Page
Loading...
