REMARK
When the key in starting switch (1) is turned to OFF posi-
tion (A), the engine stops but the power supply to the ma-
chine is not turned off immediately.
The controller terminates the system after recording the
operation state of the machine. While this process contin-
ues, the main power is maintained.
The time to keep supplying the power depends on the op-
erating condition of the machine.
METHOD FOR STARTING MACHINE (TRAVEL FORWARD AND REVERSE)
AND STOPPING MACHINE
WARNING
• Check that the direction of the track frame is proper before operating the travel levers or travel ped-
als.
If the track frame is facing the rear (if the sprocket is at the front), the machine moves in the oppo-
site direction to the direction of the operation of the travel levers or travel pedals (front and rear
travel are reversed, right and left steering are reversed).
• Check that the area around the machine is safe, sound the horn before starting the machine.
• Keep people away from the machine.
• Clear any obstacles from the travel path.
• Operate the levers carefully. The engine speed may suddenly increase during the auto-deceleration.
• When traveling, check that the travel alarm sounds normally.
PREPARATIONS FOR MOVING MACHINE
Turn fuel control dial (1) from Low idle (MIN) position (a) to
High idle (MAX) position (b).
The engine speed increases.
MACHINE OPERATIONS AND CONTROLS OPERATION
3-130
To Next Page
Loading...
Need help?
General
