Komatsu SAA6D140E-3 - Page 371

140-3 SERIES
15-13
TESTING AND ADJUSTING CYLINDER BLOCK
2. Assembly of cam bushing
• After removing the bushing, remove any
burrs or dirt, and clean the mounting hole of
the bushing.
1) Press fitting No. 3, 4, 5 bushings
Assemble bushing (4) to tool A, and press fit
the bushing until the oil hole of cylinder
clock (1) matches the oil hole of the bush-
ing.
2) Press fitting No. 2, 6 bushings
Assemble bushing (3) to tool A, and press fit
the bushing until the oil hole of cylinder
clock (1) matches the oil hole of the bush-
ing.
3) Press fitting No. 1, 7 bushings
Assemble bushing (2) to tool A, and press fit
the bushing until the oil hole of cylinder
clock (1) matches the oil hole of the bush-
ing.