15-14
140-3 SERIES
TESTING AND ADJUSTING CYLINDER BLOCK
3. Inspection
1) Using inside gauge , measure the inside
diameter of the bushing.
2) Check the clearance between the bushing
and shaft, and if the clearance is not within
the specified range, or the shaft does not
move smoothly, correct the inside diameter
of the bushing with a reamer.
3) When the inside diameter of the bushing
has been corrected with a reamer, clean all
the metal particles from the oil hole and oil
groove.
Inside diameter of cam bushing: o65 mm
Clearance of camshaft journal:
0.016 – 0.096 mm
+0.06
- 0
To Next Page
Loading...
