MAINTENANCE
3-54 WB140-2N, WB150-2N
3. Open radiator drain cock (2) (see fig.A), loosen drain valve (3)
positioned on the filter carrier head. The coolant will flow out, col-
lect it in a container with suitable capacity. Use a 12 mm wrenches.
4. Close radiator drain cock (2) (see fig.B), tighten valve (3) on the fil-
ter carrier head, and fill the radiator with new coolant. (See “FUEL,
COOLANT, AND LUBRICANTS” on page 3-7).
5. Start engine and let it idle for a few minutes; check the coolant level
again. Add coolant, if necessary. Reinstall upper radiator cap (1).
6. Fill expansion tank (4) until the maximum level is reached, then
close the engine hood.
To Next Page
Loading...
Need help?
General
