MY20 ELD Quick Start Guide
STEP 1: Download the My20 App
● Go to the Apple App Store or Android Google Play Store and search for My20 by
Konexial.
● Download the App to your smartphone or tablet.
● When prompted, you must allow the App to send you Notifications AND Location access.
NOTE: My20 ELD ONLY supports Apple iOS 10.0 (or higher) and Android 5.0 (and higher).
STEP 2: Create your My20 Account
● Tap Don’t Have an Account? Then follow the prompts.
● Username: Enter your email address - this must be a working email in order to complete
the registration process.
● Password: Must be 8 characters and include: 1 uppercase letter, 1 lowercase letter, & 1
number.
● Name: Enter first and last name.
● Company Name: Enter complete company name. Take care to include spaces, “&”
signs and apostrophes (‘) where appropriate.
Check your email for a confirmation email with a link to complete the registration process.
STEP 3: Install your My20 ELD Turn ignition OFF and remove key prior to installing your ELD.
NOTE: My20 ELD has a built-in standard 9 Pin ECM connector. If your truck has an OBDII or
6 Pin ECM port, you will need an adapter cable - sold separately. These can be purchased at www.konexial.com.
Install your My20 ELD by matching up the 9 Pin configuration on back of the My20 ELD to your
ECM cable, take care to line up the center pin which has a slot like a key. (Most ECM ports are
located under the dash or along the inside of the door frame).
Make sure the ELD is securely connected by rotating the locking collar to the right until it is fully
seated. Your ELD installation is complete when you see the pulsing green light on the face of
your ELD.
STEP 4: Connect your ELD to the My20 App
● Your ignition should still be turned off & key removed.
● Log in to the My20 App. This takes you to the LOGS screen
● Tap ELD STATUS in the top right corner. A menu will appear, tap My20ELD02.
● ELD STATUS will change to Scanning… then to Connected!
To Next Page
Need help?
General
