To Next PageTo Next Page
Need help?Do you have a question about the Kongsberg Simrad RA83P and is the answer not in the manual?
General| Brand | Kongsberg |
|---|---|
| Model | Simrad RA83P |
| Category | Marine Radar |
| Language | English |
Describes symbols used within the manual for hazard indication.
Details symbols found on the equipment itself for user safety.
Outlines essential safety and procedural precautions for servicing the radar.
Lists necessary tools and equipment for maintenance and adjustment.
Details system configurations for non-IMO and IMO radar models.
Describes the block diagrams and components of the scanner unit.
Details the modulator and magnetron used in the transmitter for 6/12kW and 25kW versions.
Describes the FEM, IF amplifier, and their functions in receiving and processing signals.
Explains the KPM-20 unit's function in monitoring radar performance.
Identifies test points and signals on the modulator PCB for maintenance.
Details the power supply circuit, its components, and output voltages.
Describes the Logic PCB, including video processing and display functions.
Details the panel PCB functions, including dimmer control and operation keys.
Explains the ATA PCB's radar interface and CPU system.
Explains setting antenna height for optimal STC function based on radar height.
Describes adjusting the automatic or manual gain settings for optimal noise display.
Guides on adjusting STC settings for different conditions like sea, harbor, or manual.
Instructions for resetting the system to factory defaults to recover from malfunctions.
Layout of the modulator PCB for 6kW and 12kW scanner units.
Layout of the modulator PCB for 25kW scanner units.
Layout of the IF amplifier PCB.
Layout of the power supply PCB.
Layout of the main logic PCB.
Layout of the panel PCB.
