14130 Cello stand
- Stable, robust and folds compactly
- Suitable for mobile use
- Instrument protected by rubber / cork rests
- 3 different width settings plus a transport setting
- Balancing floor protectors for uneven ground
- Exceptionally easy to handle, no need for tools
SAFETY NOTES
ASSEMBLY
The width of the assembled stand depends on the dimensions of the cello.
Press the pin 1 until the upper stud
2 is no longer engaged
Thank you for choosing this product. These instructions contain information about the assembly of the stand and its use.
We suggest you keep the instructions in a safe place for later use.
-Carefully place the instrument in the cradle and lean it against the rubber cover
- The ground must be level and suitable for bearing loads
- As the stand can be folded and the width adjusted, there is the potential for trapping and pinching during assembly, use and
- dismantling
- The floor protectors are made from a high quality material which, as far as possible, is free of softener;
- A non-slip underlay is recommended to protect delicate floors (certain parquets in particular).
A
B
Allow the stud 2 to engage in
one of the three holes 4
Spread the legs 3
C
If the ground is uneven adjust (+/-) the balancing
floor protectors 5
D
To Next Page
Loading...
Need help?
General
