EasyManuals Logo

Konig & Meyer 17510 User Manual

Konig & Meyer 17510
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
SAFETY NOTES
SETUP INSTRUCTIONS
Included in the delivery
1 Four swivel casters with brakes
ASSEMBLY
2 The Guardians four feet (supports) are covered with adhesive
2 rubber protective caps. These must be removed first. To accomplish
2 this use a flat, not all that sharp object (a dull kitchen knife among others)
3 Now install all 4 casters in sequence. To accomplish this, push the
3 cylindrical bolt into the hole located in the feet as far as they go.
4 Now place Guardian on the casters and check that the stand is
4 stable. Incorrectly installed casters can result in the stand rolling,
4 or being unstable. To correct this, repeat the installation steps in 3.
FUNCTION
5 Prior to placing the guitars on the stand, it is recommended that, the
5 brakes on all four casters be set, to ensure that the stand is stable and
5 does not inadvertently roll. The placement of the guitars themselves is
5 described in the Guardian instructions.
6 Always drive the Guardian with at least one hand.
WARNING!
Follow the above SAFETY NOTES. The Safety Notes suggestions
will seem obvious. We would like to ask that you do no give way
to routine and to always follow the Safety Notes when driving the
Guardian. It would be a shame if something happened to your
beautiful instruments.
TECHNICAL DATA
Thank you for choosing this product. The instructions provide directions to all of the important setup and handling steps. We recommend you keep these
instructions for future reference.
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
17510-000-55 Rev.02 03-80-280-00 2/16
- If the body and neck of the instruments are leaning against the bar and support arms, the guitars are safely stored on the Guardian stand. (please refer
- to the Guardian Instructions)
- Situations, such as bumping into the stand, can result in damaging the guitars in cases in which the guitars are not properly stored. These situations
- should be avoided.
- The use of swivel casters is very practical, but does represent potential risks:
GENERAL SAFETY NOTES
a. The loaded Guardian Guitar Stand must be "driven" carefully. The guitars and stand will thank you.
b. The furniture casters are only meant to be used for short distances at home, in studio, or on stage. The casters are not suitable for long distances
b. (for example: from the car to the stage).
b. Always ensure that the casters are in good condition, i.e. inspect them regularly to ensure that they are clean and that they function properly.
c. The surface must be suitable for swivel casters. The surface must be even, weight bearing, and free from obstacles.
d. Obstacles include (moldings, carpets, rugs, landings among others).
e. If needed, the guitars should be secured by a belt or similar to
e. prevent the guitars from falling off the stand.
SPECIFIC SAFETY NOTES
f. Install the casters carefully. In particular, when removing the four
f. rubber protection caps from the Guardian's feet, do so carefully,
f. particularly if you use a knife or similar object (see Point 2)
g. All 4 caster have brakes. The brakes have to be unlocked prior
g. to moving the Guardian.
h. Always move the Guardian slowly, to give the swivel casters the time to
h. adjust to the direction they are going in. This avoids sudden movements.
i. Avoid driving the loaded Guardian stand guitars first, in other words
i. do not lead with the side of the stand the guitars are placed into and
i. removed from. In the case of unexpected obstacles or bumps the
i. instruments could fall from the stand.
k. Always lead i.e. pull the Guardian. Always! Pushing the Guardian
k. is not permitted and is a source of risk.
17510 Caster set for »Guardian«
Easy installation - for mobility for short distances
Material
Housing, wheel core, brake: PA-6, black
Ring: Polyurethane, gray/black
Pin: Steel
Dimensions
Casters ø 37 mm, width 48 mm,
height 44/66 mm, pin ø11 x 22 mm
Data
Casters are soft for hard floors do not leave
scuff marks and are non-abrasive.
Load: 70 kg, weight: 88 g/Unit.
Packaging Individual Box 98 x 70 x 125 mm / for 4 casters

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Konig & Meyer 17510 and is the answer not in the manual?

Konig & Meyer 17510 Specifications

General IconGeneral
BrandKonig & Meyer
Model17510
CategoryRacks & Stands
LanguageEnglish

Related product manuals