- In the event of workstation maintenance pay attention to possible risks
- (wedging, knocking over)
- To care for the product use a damp cloth and a non-abrasive cleaning agent.
FAULT-FINDING (F) and REPAIR (R)
F: Stand is not stable
F: R: Check the surface
F: R: Check the screws
F: Height of the stand needs to be adjusted
F: R: Adjust the extension tube (2 possible height settings, see A.)
F: Extension tube is not stable
F: R: Check if the locking pin has clicked into position and tighten the wing nut 11
CHECK, MAINTENANCE, CLEANING
D. PLACEMENT of the INSTRUMENT
D.1 Suitable for E/A-Guitars and Bass Guitars
D.1 13 Place the neck of the guitar in the support arms,
D.1 14 then carefully lean the guitar against the
D.1 14 cushioning.
E. DIMENSIONS
A. ASSEMBLY
F. 5 Loosen the wing nut.
F. 8 Press the locking pin - if needed twice, until the
F. 8 extension tube retracts into the outer tube.
F. 11 Re-tighten the lower wing nut
F. 11 - retract the legs (refer to setup instructions)
TECHNICAL DATA
Material
Tubes, sheet metal parts, screws - Steel, black
Handles, guides - Polyamid (PA), black
End caps, support arm cushioning - TPE, black
Cushioning - PU-Foam material, gray
Dimensions
Setup height: 800 - 1300 mm
Base diameter / Required space ø 760 mm
Packaging Box
Weight 2.2 kg
USAGE NOTES / FUNCTION
A. HEIGHT of the SUPPORT ARMS - 2 settings
A.1 Lower settings: primarily for guitars
A.1 5 Loosen the wing nut,
A.1 6 pull the extension tube upwards until the...
A.1 7 ...locking pin clicks into the first hole.
A.2 Upper settings: primarily for bass guitars
A.2 8 Press the locking pin,
A.2 9 pull the extension tube upwards until the...
A.2 10 ...locking pin clicks into place.
A.3 Secure the respective setting ...
A.3 11 ...tightening the wing nut.
B. POSTION of the INSTRUMENT BODY CUSHION
B.1 Variable Adjustment
B1 12 Place the instrument body cushion in the
B1 12 desired position.
C. SUPPORT ARM FUNCTION
C.1 Each of the movable support arms adjust to the
C.1 respective headstock.
C.2 Keeps thick headstocks in position.
C.3 Support arms are automatically open for user friendly
C.3 placement of the guitar into the support arms.
ADJUSTMENT
To Previous Page
Loading...
