Konig CMP-BARSCAN21 - Group 5: Scan mode; Trigger modes; Continuous modes

12
Group 5: Scan mode
Enter group Exit
1. Trigger On/Off
2. Trigger On/Good read Off (*)
3. Trigger On/Good read Off/Delay Timeout =?
4. Continuous/Trigger Off
5. Continuous/LED Always on
6. Continuous/No Trigger
Delay Timeout Setting:
1.) Scan the Enter group 5 label.
2.) Scan the label 3 “Delay Timeout”.
3.) Scan the two digit labels in Table-Hex.
4.) Scan the Confirm label in Table-Hex.
5.) Scan the Exit label.
Note: Scan mode setting is only available for the CCD/Laser type scanner.