Konig SEC-APD10 User Manual

SEC-APD10
MOTION ALARM
With Telephone Dialer
Description:
1. PIR sensor
2. Siren
3. Microphone
4. Battery LED indicator
5. Keypad
6. Telephone connection
7. Battery Compartment
Battery installation:
1. The battery compartment is accessed from
the rear of the alarm by removing the screw
from the bottom and lifting the back cover
(see figure B).
2. Insert 4x AAA size
batteries (not included)
according the polarity as
shown in figure C.
3. When the last battery is inserted the alarm will
beep very loud to indicate that the batteries are
installed properly. Replace the back cover.
ENGLISH
INSTRUCTIONS

Konig SEC-APD10 Specifications

General

Sensor type	-
Alarm decibels	130 dB
Alarm function	Yes
Connectivity technology	Wireless
Maximum range	6 m
Dimensions (WxDxH)	167 x 67 x 43 mm
Battery type	AAA
Number of batteries supported	4
Product color	White

Summary

Battery Installation Guide

Accessing the Battery Compartment

Inserting Batteries

Battery Installation Confirmation

Alarm Programming

Setting Security Code

Set a 4-digit security code immediately after inserting batteries. '0' is for arming.

Programming Telephone Numbers

Program up to 3 telephone numbers (max 16 digits each) for alerts.

Message and Alarm Modes

Recording a Personal Message

Activating Silent Alarm

Alarm Operation

Arming the Alarm

Press '0' to arm; 30 seconds to leave. Motion detection triggers dialer after delay.

Disarming the Alarm

Enter the 4-digit security code within 10 seconds when entering to disarm.

Alarm Activation Sequence

Dials stored numbers sequentially if not answered; siren sounds after delay.

Important Information

Safety Warning

Only authorized technicians should open the product. Do not expose to moisture.