Why does my Konsberg Marine Equipment AIS unit keep restarting?
The AIS unit may be restarting because the external power source doesn't have a sufficient current rating. It is recommended to use a 4A power source. Also, ensure the power cables meet the specifications for the power consumption.
What to do if Konsberg AIS 200 is not getting data input from the main GPS/GNSS source?
First, check that the corresponding cable connections are correctly connected. Then, verify the serial line communication settings (baud rate, parity, number of bytes transmitted, and number of stop bits) between the transmitting (vessel GPS/GNSS receiver) and receiving ends. Finally, ensure that the position output format from the GPS/GNSS receiver matches the expected input position format.
What should I do if my Konsberg Marine Equipment GPS receiver fails?
First, disconnect the antenna cable at the rear of the Mobile Unit and check the voltage output on the GPS antenna connector; it should be approximately 4.8 – 5.0 V if the GPS receiver is supplying voltage to the antenna. Then, try disconnecting and reconnecting the power to see if the Mobile Unit starts normally. If valid GPS position data is still not being received, reset the GPS receiver from the MKD menu.
What to do if Konsberg AIS 200 heading from vessel heading sensor is not working?
Check that the cable connections are correctly terminated. Also, check the serial line communication (baud rate, parity, number of bytes transmitted, number of stop bits) between the transmitting (vessel heading sensor) and receiving (parameters to be checked from the MKD unit) end. Finally, check that the heading output format from the compass matches the expected input heading format.
How to troubleshoot a Konsberg AIS 200 power supply failure?
First, check that external power has been connected to the rear connectors. Verify that the supplied power meets the technical power specifications. Ensure that the power cable dimensions are a minimum of 2.5 mm[2].
What to do if my Konsberg AIS 200 Marine Equipment VHF transceiver fails?
Try disconnecting and reconnecting the power to see if the Mobile Unit starts as expected.
How to check Konsberg AIS 200 GPS and VHF antenna cable connections?
Ensure that the GPS antenna is disconnected. Check that the Ohm reading between the center and the screen should normally be infinite if there is no short-circuit in the cable. To further test, create a short-circuit at the opposite end of the cable and measure the resistance. The reading should then be approximately 0 Ohm.
Overview of the manual's content and organization.
Lists documents cited within this manual.
Defines technical terms and acronyms used throughout the document.
Covers safety, environmental, and health precautions for the AIS 200.
Details warranty limitations and exclusions.
Specifies voltage input and power consumption details.
Defines accepted data input formats for navigation sensors.
Lists detailed technical specifications for system components.
Guidance on installation personnel qualifications and procedures.
Instructions for unpacking and inspecting equipment.
Recommended steps for installing the AIS 200 system.
Details recommended cabling practices and types for antennas and power.
Guidelines for connecting external sensors and systems to the AIS 200.
Describes the PI and Pilot ports for external equipment connections.
Overview of system configuration methods available for the AIS 200.
Steps for configuring the AIS 200 using the internal Minimum Keyboard Display.
Overview of maintenance responsibilities and scope for the AIS 200.
Recommended checks for ensuring proper mounting and connections.
Using LED indicators for monitoring status and diagnosing issues.
Categorizes common hardware issues and their potential causes.
Describes the recommended wiring for the digital interface.
Explains proprietary sentences for system configuration and service.
Configuring security levels and PIN codes for the optional MKD.
Details setup file parameters for Inland Waterway functionality.
General| Brand | Konsberg |
|---|---|
| Model | AIS 200 |
| Category | Marine Equipment |
| Language | English |
To Next Page