What to do if Konsung Medical Equipment doesn't work after turning it on?
If the light and concentrator don’t work after turning on the switch, it might be due to several reasons. First, ensure the plug is firmly inserted into the switch; push it in if necessary. Second, check if there is power. Third, the overload protector might be activated; if so, press the button of the overload protector.
Why does my Konsung KSOC Medical Equipment light work but the concentrator doesn't?
If the light works but the concentrator doesn’t, it could be due to air compressor protection, in which case you should renew the oxygen concentrator. Alternatively, the inlet or outlet might be jammed; clean the filter and check for any obstructions in the intake. Lastly, if the ambient temperature is lower than 5?, try raising the ambient temperature.
What to do if Konsung KSOC Medical Equipment cannot obtain the requested current capacity?
If you cannot obtain the requested current capacity, it might be because the nose sucker is jammed or damaged; in this case, change or rectify the oxygen tubes. Another possibility is that the mask is jammed or damaged; take down the wet bottle and clean or change it.
Important safety warnings and instructions for initial use of the oxygen concentrator.
Explanation of the control panel's display, indicator lights, and operational buttons.
Detailed steps for operating the concentrator, including connecting, starting, adjusting, and shutting down.
Details the acoustic and visual alarms, including power, pressure, and fault codes for monitoring.
Instructions for cleaning the external casing of the oxygen concentrator.
Steps for properly cleaning and maintaining the humidifier component of the concentrator.
Procedure for cleaning the filter sponge to ensure optimal performance and longevity.
Guidance on replacing the intake air filter and resetting the overload protector.
General| Category | Medical Equipment |
|---|---|
| Power Supply (Pulse Oximeter) | 2 x AAA batteries |
| Oxygen Output | 1-5L/min |
| Oxygen Purity | 93%±3% |
| Power Consumption | ≤300W |
| Product Name | KSOC Series |
| Intended Use | Oxygen therapy and SpO2 monitoring |
| SpO2 Accuracy | ±2% (70%-100%) |
| Pulse Rate Accuracy | ±2 bpm |
| Automatic Shutdown | 8 seconds |
| Operating Temperature (Pulse Oximeter) | 5°C to 40°C |
| Type | Oxygen Concentrator |
| Operating Temperature (Oxygen Concentrator) | 10°C to 40°C |
| Power Supply (Oxygen Concentrator) | AC 220V ± 10%, 50Hz |
To Next Page
