https://www.kontron.com/en/quality-management .
Disposal and recyclingDisposal and recycling
Kontron’s products are manufactured to satisfy environmental protection requirements where possible. Many of the components used are capable of being
recycled. Final disposal of this product after its service life must be accomplished in accordance with applicable country, State and/or local laws or
regulations.
Waste electrical and electronic equipment directiveWaste electrical and electronic equipment directive
This product contains electrical or electronic materials. If not disposed of properly, these materials may have potential adverse effects on the environment
and human health. The presence of this logo on the product means it should not be disposed of as unsorted waste and must be collected separately.
Dispose of this product according to the appropriate local rules, regulations and laws.
WEEE directive logo WEEE directive logo
General power safety warnings and cautionsGeneral power safety warnings and cautions
As a precaution and in case of danger, the power connector must be easily accessible. The power connector is the product’s main disconnect device.
All operations on this product must be carried out be sufficiently skilled personnel only.
Electric Shock!Electric Shock!
Before installing a non-hot-swappable Kontron product into a system always ensure that your main power is switched off. This also applies to
the installation of piggybacks. Serious electrical shock hazards can exist during all installation, repair, and maintenance operations of this
product. Therefore, always unplug the power cables and any other cables which provide external voltages before performing any work on this
product.
An earth ground connection to the vehicle’s chassis or a central grounding point shall remain connected. The earth ground cable shall be the last
cable to be disconnected or the first cable to be connected when performing installation or removal procedures on this product.
Risk of explosion if battery is replaced by an incorrect type.Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Circuit overloadingCircuit overloading
Do not overload the circuits when connecting this product to the supply circuit as this can adversely affect overcurrent protection and supply wiring. Check
the supply equipment nameplate ratings for correct use.
Do not connect Vbat+ as a source on pins rated for lower voltage. This will damage the platform interface.
Do not connect Vbat+ as a source to USB, display port and audio pins. This will damage the platform interface.
Reliable earth-groundingReliable earth-grounding
Always maintain reliable grounding of equipment.
S1901_EvoTrac_User_Guide
July 14, 2023 www.kontron.com // 7
To Next Page