INSTALLATION AND PLACEMENT
START USING
Before using your freezer, remove all packaging
materials including foam pads and tapes inside
the unit, remove the protecve film on the door
and the appliances’ body.
The freezer should be placed in well venlated
indoor area, the ground should be flat and
sturdy enough to support the unit once filled.
When choosing the locaon keep away from heat
sources and avoid direct sunlight. Do not store the
freezer in moist areas as this cause the unit to rust or
generate malfuncon.
Allow sufficient clearance to insure proper air
circulaon: 30 cm (12’’) at the top and 10 cm (4’’) on
each sides and back of the unit.
Before connecng to the power so urce, let the appliance
stand for 2-3 hours.
The freezer should run 4 hours before loading fresh or
frozen foods.
To Next Page
Loading...
Need help?
General
