EasyManua.ls Logo

Kooper 2159711 - Appliance Installation Instructions; Surface and Clearance Requirements; Power Connection

Kooper 2159711
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
tripping over a longer cord.2. If a long cord set or extension cord isused:
1)The marked electrical rating of the cordset or extension cord should be at least as great as the electrical
rating of the appliance.
2) The extension cord must be a grounding-type 3-wire cord. 3)The long cord should be arranged so
that it will not drape over the counter top or tabletop where it can be pulled on by children or tripped over
unintentionally.
30 cm
7,5 cm
7,5 cm
opening
INSTALLATION
1 SELECT A LEVEL SURFACE THAT PROVIDE ENOUGH OPEN SPACE FOR THE INTAKE
AND/OR OUTLET VENTS
A minimum clearance of 7.5 cm is required between the oven and any adjacent walls. One side must be
open.
(1) Leave a minimum clearance of 30 cm above the oven.
(2) Do not remove the legs from the bottom of the oven.
(3) Blocking the intake and/or outlet openings can damage the oven.
(4) Place the oven as far away from radios and TV as possible. Operation of microwave oven may cause
interference to your radio or TV reception.
2. PLUG YOUR OVEN INTO A STANDARD HOUSEHOLD OUTLET. BE SURE THE VOLTAGE
AND THE FREQUENCY IS THE SAME AS THE VOLTAGE AND THE FREQUENCY ON THE
RATING LABEL.
WARNING: Do not install oven over a range cooktop or other heat-producing appliance. If installed near or
over a heat source, the oven could be damaged and the warranty would be void.
THE ACCESSIBLE SURFACE MAY BE HOT DURING OPERATION.

Related product manuals