INSTRUCTIONS FOR USE
1. Before first use, the battery must be fully charged (approx. 5 hours). Before use, be sure to
remove all stickers and bags from the packaging.
2. Clean all parts of the device thoroughly (observe the cleaning instructions in the CLEANING AND
MAINTENANCE section).
3. Make sure that the tumbler (6) is firmly tightened on the base (9): due to the presence of a safety
button, if the tumbler is not correctly seated, the blades will not operate.
-To turn the appliance on, press twice quickly the power button (11). This is to prevent unintentional
switching on during washing (see the cleaning and maintenance section).
4. It is recommended to use the product at intervals of no more than 60. Then discontinue use and
wait a few minutes before using again.
NOTE: Provided with safety stop function: if the glass is not properly in place, the blender will not
operate.
PREPARATION
Wash the fruit and cut it into small pieces of
about 1.5 cm (remove any seeds, stones or
fruit core). 2. Put the fruit into the glass filling
to a maximum of 60% of the capacity, add
the necessary water reaching a maximum of
80% of the capacity of the mug. NOTE: Do not
exceed the maximum allowable capacity of the
glass and do not start the appliance without
also putting in the liquid component.3. Turn the
blender upside down and shake it to mix the
contents, put it back in place and start it. To get a
good smoothie, shake the blender slightly during
operation.
NOTE: After inserting all the necessary
ingredients, tilt the blender and, only after doing this, start the blades. Shake the blender slightly
and gradually return it to the upright position. Repeat this operation until the desired consistency
is achieved. In order not to overload the blades, help yourself, if necessary, by adding more water,
which you will be able to remove through the strainer.
Scan the QR-Code to see the preparation video
To Next Page
Loading...