19 20
40-150CM
946 i-SIZE
Pull out the belt from the belt ALR (Automatic Locking Retractor ).
Diagonal belt through the same side of guidance (11) on headrest,
then pull the diagonal belt and lap belt together through the other
side guidance (24) on the seat base.
9.1
TIP! Keep the diagonal belt at the position of belt guidance between
the outside of the neck and shoulder (in the middle of point and
point ).
Lock the tip of the buckle into the vehicle seat buckle with a clicking
sound. Follow the direction of arrow to tighten belt, and put
redundant belt into ALR. Shake the child safety seat to make sure it is
securely attached.
9. FORWARD FACING 1536KG INSTALLATION
Store 5-point harness
Install the child safety seat with ISOFIX (refer to page 14)(1.2)(1.3).
If you don't have ISOFIX, please ignore this step. Install the child
safety seat with vehicle belt.
(Refer to page 17 )<store 5-point harness>
Install the child safety seat with only BELT or BELT + ISOFIX or
BELT + ISOFIX + TOP TETHER
The vehicle belt must not be twisted or have their places changed over.
WARNING!
TIP! The importance of ensuring that any lap vehicle seat belt is worn
low down, so that the pelvis is rmly engaged, shall be stressed.
8. FORWARD FACING 918KG INSTALLATION
Install the child safety seat with BELT or BELT + ISOFIX
Install the child safety seat with ISOFIX (refer to page14) (1.2)(1.3).
If you don't have ISOFIX, please ignore this step. Install the child
safety seat with vehicle belt.
Pull out the belt from the belt ALR (Automatic Locking Retractor ).
Diagonal belt pass through the gap between the headrest and
backrest, then pull the diagonal belt and lap belt together through the
other side guidance (24) on the seat base.
8.1
TIP! When installed in forward facing, the path of the lap belt has the
same red guide on the cloth cover.
Lock the tip of the buckle into the vehicle seat buckle with a clicking
sound. Follow the direction of arrow to tighten belt, and put
redundant belt into ALR. Shake the child safety seat to make sure it is
securely attached.
The vehicle belt must not be twisted or have their places changed over.
WARNING!
8.2
9.2
20
If you want to use top tether + belt + ISOFIX, can refer page 14 (1.2)
(1.3), page18 (7.1) (7.2) (7.3).
7.3
Make sure the top tether strap is tightened up and make
sure the top tether adjuster (20) indicator turn into green safety color.
Make sure the top tether goes through the gap between headrest (3)
and backrest.
TIP! The diagonal vehicle seat belt section must run
diagonally backward. You can adjust the course of the belt
with your vehicle's ALR on both sides.
To Next Page
Loading...