HOW TO ATTACH AUXILIARY WHEELS
Your E1 comes with auxiliary wheels you can attach, which provide a more practical and
comfortable way of carrying your Beam. To attach:
1. Lay your Beam on its side, and locate 4 screws (2 on each side) that are towards the front
wheel, close to the bottom of the deck.
2. Unscrew the 4 screws.
3. Line up the holes on the platform attached to the auxiliary wheels, with the holes on the
Beam where the screws were. Make sure the auxiliary wheels are closest to the front end of
your Beam.
4. Place a screw in each hole and tighten to secure the auxiliary wheels to your Beam.
Once properly attached, you can use the auxiliary wheels to roll your E1 when it's not in use.
Simply fold up the Beam and lift it up by the handlebar (in a position where the wheels are on the
bottom and the handlebar is on top), with the auxiliary wheels being the only wheels that should
be touching the ground. Pull it behind you for easy transporting. Adjust the handlebar to a height
that's comfortable for you.
To Next Page
Loading...