Kopp RM-686 User Manual

Clever sein.
Kopp einschalten.
6 7
Insert batteries
Battery is not included in the package!
Please open the battery cover on the back of the
device - to do this, press the tab down slightly.
Insert two alkaline batteries (1.5 V, AA) into the battery
compartment and close the battery cover again.
Input the code manually
1. Switch on the device to be operated (TV, DVD,
SAT, etc.).
SAT CODE
AKAI 5010.5207.5212.5254.
5277.5292.5300
TV DVD
SAT
1 2 3
4 5 6
7
-
+
8 9
0
CODETV/AV
3. Press the equipment
button (such as: SAT key),
and the indicator light
will flash.
2. Find out the
corresponding brand
code of your device in
the enclosed code list.
Example: your SAT
equipment brand is
“AKAI“, and the first
code of the brand is “5010“.
TV DVD
SAT
1 2 3
4 5 6
7
-
+
8 9
0
CODETV/AV
4. Press the “CODE“ button
for two seconds and
release the button when
the indicator light is on
for a long time.
TV DVD
CODE
SAT
1 2 3
4 5 6
7
-
+
8 9
0
5. Input the found
four-digit code in order
(such as 5010).
Please note:
If the code entered is incorrect, the indicator
flashes three times and then lights up
continuously to indicate that the entry must be
repeated. When the code entry is complete, the
indicator light goes out.
6. Check whether the press operation of the remote
control is normal. If yes - the installation is
successful. If no - please repeat steps 4–6 and
enter other codes of the corresponding brand.

Universal remote control 7 in 1, RM-686
Instruction manual
Input the code automaticaly
1. Switch on the device to be operated (TV, DVD,
SAT, etc.).
TV DVD
CODETV/AV
SAT
1 2 3
4 5 6
7
-
+
8 9
0
2. Press the equipment key
(such as: TV key), and the
indicator light will flash.
TV DVD
SAT
1 2 3
4 5 6
7
-
+
8 9
0
CODETV/AV
3. Press the “CODE“ button
for two seconds and
release the button when
the indicator light is on
for a long time.
TV DVD
CODE
SAT
1 2 3
4 5 6
7
-
+
8 9
0
4. Enter the number “1111“
and the indicator light
starts flashing.
TV DVD
SAT
1 2 3
4 5 6
7
-
+
8 9
0
CODETV/AV
OFF
5. Place the remote control
at the front of the
equipment you want to
control. The remote
control sends an on/o
signal. After the
equipment is closed,
press “CODE“ key within
two seconds and the
indicator light will be o.
6. Check whether the press operation of the remote
control is normal. If yes - the installation is
successful. If no - please repeat steps 3–5.

Kopp RM-686 Specifications

General

Brand	Kopp
Model	RM-686
Category	Remote Control
Language	English