4. As well as
ῧ
Ajst(L)”, “Ajst (R)” and a 4 digits figure are indicated in the LCD.
If the value is leas than 0010, the test is O.K.. Press the 16 knob at the right bottom. If
the value is over it, it is required to adjust the valve. Adjust the variable resistors
which correspond to the channels referring to the photo above.
5. Once the balance of L/R is automatically adjusted, “ValvGMax GainMx” is
indicated in the LCD. Turn the TUBE GAIN knob to MAX, and press the 16 knob.
6. Check the L/R balance of TUBE GAIN MAX, and return to the normal mode.
End.
To Next Page
Loading...
