Korg Kaoss DJ - Appendix; MIDI Message List

10
KAOSS DJ
Troubleshooting
Power won’t turn on
→ IfyouconnecttheKAOSSDJtoyour
computer via a USB hub, it might not
power-on because of insufficient power. In
that case, you should connect the KAOSS
DJ directly to a USB connector on the
computer itself, not via a USB hub.
→ TheremightbeaproblemwiththeUSB
cable you’re using. Check whether the
power turns on with the included USB
cable.
The KAOSS DJ is not recognized as a USB
device
→ TheremightbeaproblemwiththeUSB
cable you’re using. Try using a different
cable.
→ Checkwhethertheremightbeaproblem
with the USB A port of the computer or
other device where the KAOSS DJ is
connected.
→ TheKAOSSDJmightnotberecognizedif
you use a commercially available long
length USB cable. Even if you’re using a
long length USB cable, the KAOSS DJ
mightberecognizedifyouconnectviaa
self-powered hub; however even in this
case, you should use the included USB
cable between the KAOSS DJ and the
self-powered hub.
Buttons are not operating according to
machine indications
→ Thesoftwarebeingusedmaybeincom-
patible with some functions or have
different operations.
No sound is output
→ Makesurethatyourpoweramporhead-
phones are connected to the correct jacks.
→ Makesurethattheconnectedpoweramp
or other equipment is turned on and set to
an appropriate volume.
is no audio input, you will return to the program
select screen before the auto BPM function has
been completed. If you want to display the
BPM again, press the Tap button.
Specifying the scale
You can assign a scale to the touchpad.
TIP The program determines whether this setting
has an effect. Refer to the operation guide.
1. Hold down the Shift button and press the
Hold button; the abbreviated name of the
currently specified scale appears in the dis-
play.
2. Turn the program/value knob to change the
scale.
3. After you make the change, the program
indication reappears when a certain length
of time has elapsed.
TIP By pressing the Shift button you can make the
program indication reappear immediately.
Specifying the key (tonic)
Here’s how to specify the key (root note) of the
scale.
TIP The program determines whether this setting
has an effect.
1. Hold down the Shift button and press the
Tap button; the currently specified key ap-
pears in the display.
2. Turn the program/value knob to change the
key.
3. After you make the change, the program
indication reappears when a certain length
of time has elapsed.
TIP By pressing the Shift button you can make the
program indication reappear immediately.
For some settings, there might be no sound, or
noise might be output.