35
Quick Start
Simple combination editing
A combination is a set of multiple (up to eight) pro-
grams, and allows you to create complex sounds that
could not be produced by a single program.
You can edit a combination in Combination P1: Edit-
program/Mixer–P9: Edit-Master Effect, but can also
make settings for “Program Select,” “Status,” “Pan,”
and “Volume” in Combination P0: Play as well.
If you wish to keep the results of your editing, you
must Write the combination into memory before
selecting another combination or turning the
power off. (
☞p.38)
As an example, here’s how to do some simple editing
on combination Bank A064: ModernPiano.
1 Press the [COMBI] key to enter Combination
mode.
2 Select preset combination Bank A064: ModernPi-
ano.
This combination layers (simultaneously sounds)
the programs of timbre 1 and timbre 2. Timbre 1
sounds B001: Attack Piano, a piano with a crisp
attack. Timbre 2 sounds B081: Vintage EP, a classic
electric piano. These two programs are layered to
produce a piano-type sound that you may have
heard in various contexts.
A timbre consists a of program together with mul-
tiple parameters that control that program. A com-
bination can use up to eight of these timbres.
Selecting the program for a timbre
3 Press the Prog. Select tab.
When a timbre’s “Status” is turned Off, the pro-
gram assigned to that timbre will not sound. If the
“Status” is set to INT, the program will sound. Try
setting timbres 1 and 2 alternately to INT and Off,
and listen to the result.
4 Now let’s change the program of timbre 2 to a dif-
ferent program. (Make sure that the “Status” of
timbres 1 and 2 are set to INT.)
Press the timbre 2 “Bank/Program” switch (it will
be highlighted).
Use the [BANK] keys, numeric keys [1]–[9],
[ENTER] key, [VALUE] slider, [VALUE] dial, and
[ ][ ] keys to select a program.
Alternatively, you can select a program from a
popup menu. Press the popup button, and select the
desired program from the popup menu that
appears.
5 You can also select programs by category. Press
“Category” for timbre 2.
The “Category/Timbre2 Program” select menu will
appear. In this combination, a program from the
“Keyboard” category is selected for both timbres 1
and 2.
An example of editing
Timbre 2
Timbre 1
Only timbre 1 will sound
Only timbre 2 will sound
Simple combination editing
To Next Page
Loading...