Korg ZERO4 - PHONO Input Test

・
Confirmation of PHONO INPUT
(
RCA
)
C
onnect the ZERO4 and the D3200 like following.
ZERO4 CH1 PHONO L - D3200 MASTER OUT L
ZERO4 CH1 PHONO R - D3200 MASTER OUT R
Set the MASTER FADER of the D3200 to "60".
Set all
the
FADERs of the ZERO4 to "0".
CH FADER CURVE
M
AX
Set
the CH FADER CURVE (front , second knob from right) of the ZERO4
to MAX (right end)
. (See right photo)
Set the CH1,2,3,4
INPUT SELECTORs to "PHONO".
Connect the headphones to the standard jack of ZERO4 MONITOR. (front left side)
P
ress the PLAY switch of D3200. (Demo song starts.)
Set the CH1
CH
FADER to "10".
Y
ou can hear the demo song of the D3200 throuh the headphones,
confirm that there is not noise and fragmentary sound.
Set the CH1
CH
FADER to "0".
Pull out the cable from the CH1 PHONO L (ZERO4) and connect to the CH2 PHONO L..
Pull out the cable from the CH1 PHONO R (ZERO4) and connect to the CH2 PHONO R.
Set the CH
2
CH
FADER to "
1
0".
Y
ou can hear the demo song of the D3200, confirm that there is not noise
and fragmentary sound.
Set the CH
2
CH
FADER to "0".
Pull out the cable from the CH2 PHONO L (ZERO4) and connect to the CH3 PHONO L..
Pull out the cable from the CH2 PHONO R (ZERO4) and connect to the CH3 PHONO R.
Set the CH
3
CH
FADER to "
1
0".
Y
ou can hear the demo song of the D3200, confirm that there is not noise
and fragmentary sound.
Set the CH
3
CH
FADER to "0".
Pull out the cable from the CH3 PHONO L (ZERO4) and connect to the CH4 PHONO L..
Pull out the cable from the CH3 PHONO R (ZERO4) and connect to the CH4 PHONO R.
Set the CH
4
CH
FADER to "
1
0".
Y
ou can hear the demo song of the D3200, confirm that there is not noise
and fragmentary sound.
Set the CH
4
CH
FADER to "
0".
P
ress the STOP switch of the D3200. Then the demo song stops.
P
ressing the STOP of the D3200, press the REW. (the song returns to the top.)
P
ull out the cables which are connected.
KORG INC.
7／102007/4/23
QCI-5800 Page
ZERO4 (X-5800) Check before Shipping
Revised
No.
Date