Korg ZERO4 - Output Terminal Functionality Check

P
ress the "+48V" switch of ZERO4 (under left of MIC IN).
C
onfirm that the "ON" LED left side of the switch turned on.
P
ress the "+48V" switch of ZERO4 (under left of MIC IN).
*In this OUTPUT check,
you can use other equipments
・
Check of OUTPUT terminal
instead of D3200 and Audio-analyzer.
Please use which you can prepare.
S
etting and reading of the song
P
ressing the SONG switch of the D3200, press the "+" or "-" switch for
several times
a
nd the song name which is made by next item is displayed
then release your fingers from the switches.
After few seconds, the reading
data
is completed.
Set the CH1 and CH2 FADERs to "0".
Press the channel keys of CH1 and CH2 and let the red LED turned on.
Set the MONITOR LEVEL to "0".
Set the PAD to "ON"(under the INPUT 1,2 TRS)
Rotate the TRIM(under the PAD) to the left end.
C
onnect headphones to the PHONES.
CH1,2FADER
C
onnect ZERO4, Audio-analyzer( or oscillator), D3200 like following.
ZERO4
C
H1 LINE L/MONO(TRS) - Audio-analyzer
ZERO4
C
H1 LINE R(TRS) - Audio-analyzer
ZERO4 MASTER OUT L(XLR) - D3200 INPUT1 XLR terminal
ZERO4 MASTER OUT R(XLR) - D3200 INPUT2 XLR terminal
Set the
CH
1 INPUT SELECTOR of ZERO4 to "LINE ".
Set the
CH
1 GAIN of ZERO4 to the center (12o'clock)
CH1,2 key red LEDs turned ON.
I
nput the sine-wave 440Hz 0dBu from the Audio analyzer (or oscillator).
S
et the CH1 module FADER to "10".
C
onfirm that the sine-wave can be heard from the headphones which is connected to D3200.
(Adjust the MASTER FADER and PHONES LEVEL of D3200 appropriately.)
S
et the CH1 module FADER to "0".
Take out the following connection.
ZERO4 MASTER OUT L(XLR) D3200 INPUT1 XLR
ZERO4 MASTER OUT R(XLR) D3200 INPUT2 XLR
Connect the ZERO4 and D3200 like following.
ZERO4 BOOTH OUT L(TRS) D3200 INPUT1 TRS
ZERO4 BOOTH OUT R(TRS) D3200 INPUT2 TRS
I
nput the sine-wave 440Hz 0dBu from the Audio analyzer (or oscillator).
S
et the CH1 module FADER to "10".
C
onfirm that the sine-wave can be heard from the headphones which is connected to D3200.
(Adjust the MASTER FADER and PHONES LEVEL of D3200 appropriately.)
S
et the CH1 module FADER to "0".
Turn the power OFF of ZERO4.
The check has completed.
Set the ZERO4 as the factory setting.
KORG INC.
10／102007/4/23
QCI-5800 Page
ZERO4 (X-5800) Check before Shipping
Revised
No.
Date