Korg ZERO4 - MIC Input Test

・
Confirmation of MIC INPUT
(MIC GAIN HIGH
/LOW
)
*This check uses D3200,
instead of a microphone
C
onnect the ZERO4 and the D3200 like following.
If you have a microphone, please use it.
ZERO4
MIC
(TRS) terminal - D3200 MASTER L
Set the MASTER FADER of D3200 to "40".
Set the
CH
1,2,3,4 INPUT SELECTORs to "MIC".
C
onfirm that the MIC GAIN switch of the ZERO4 (under right of MIC IN) is "HIGH".
Set the
CH
1,2,3,4 GAIN to the center.
P
ress the PLAY switch of D3200. (Demo song starts.)
S
et the CH1 module FADER to "10".
Y
ou can hear the demo song of the D3200 through the headphones,
confirm that there is
not
noise and fragmentary sound.
P
ress the MIC GAIN (under right of MIC IN) and set it to "LOW".
C
onfirm that the sound of the headphones becomes smaller.
S
et the CH1 module FADER to "0".
P
ress the MIC GAIN (under right of MIC IN) and set it to "HIGH".
S
et the CH2 module FADER to "10".
C
onfirm that there is
not
noise and fragmentary sound
from the headphones
.
P
ress the MIC GAIN (under right of MIC IN) and set it to "LOW".
C
onfirm that the sound of the headphones becomes smaller.
S
et the CH2 module FADER to "0".
P
ress the MIC GAIN (under right of MIC IN) and set it to "HIGH".
S
et the CH3 module FADER to "10".
C
onfirm that there is
not
noise and fragmentary sound
from the headphones
.
P
ress the MIC GAIN (under right of MIC IN) and set it to "LOW".
C
onfirm that the volume of the headphones becomes smaller.
S
et the CH3 module FADER to "0".
P
ress the MIC GAIN (under right of MIC IN) and set it to "HIGH".
S
et the CH4 module FADER to "10".
C
onfirm that there is
not
noise and fragmentary sound
from the headphones
.
P
ress the MIC GAIN (under right of MIC IN) and set it to "LOW".
C
onfirm that the volume of the headphones becomes smaller.
S
et the CH4 module FADER to "0".
P
ress the MIC GAIN (under right of MIC IN) and set it to "HIGH".
P
ress the STOP switch of the D3200. Then the demo song stops.
P
ressing the STOP of the D3200, press the REW. (the song returns to the top.)
P
ull out the cables which are connected.
KORG INC.
ZERO4 (X-5800) Check before Shipping
Revised
No.
Date 9／102007/4/23
QCI-5800 Page