KP Electronic Systems ATS100 User Manual

ATS100™
Long-Range
Synthesized Radio
Alarm Transmitter
Programming Guide
Web Site: www.kpsystems.com
ISRAEL Office
Email: info@kpsystems.com
Tefen Industrial Park, Tefen 24959
Tel: 972-4-987-3066 Fax: 972-4-987-3692
USA Office:
KP ELECTRONICS INC.
Email: info@kpelectronics.com
109 Tudor Drive, North Wales, PA 19454
Tel: (215) 542-7460 Fax: (215) 542-7461
P.N.: Book 039 Rev: 09 Pg.2 of 2 Approved: Amir S.
03/10/06
ATS100™ Programming Guide
Connect ATS100™ to a PC using an
RSINT001™ adaptor (see Figure 1).
The following communication parameters
can be programmed or modified:
• Protocol
• Station address
• System
• Group
• Number of words (in a burst)
• Alarm repetitions
• Test repetitions
• Periodic test (hours:min)
• Parity
• Input delay
• Input polarity
• Transmit frequency (MHz)
Figure 1: ATS100™
PC Connection Configuration
Operating Instructions
• Connecting ATS100™ to
GUP5000™ utility program
• Changing Devices
• Loading Device Parameter Values
• Changing Device Parameter Values
• Updating Parameter Value Changes
• Confirming Parameter Value Changes
• Activating SELF TEST
Connecting ATS100™ to GUP5000™
1. Connect ATS100™ to a PC using
the RSINT001™ adaptor (see
Figure 1).
2. Click StartPrograms
KP UtilitiesGUP5000, or click
shortcut.
.
Changing Devices
Various KP devices can be programmed
using GUP5000™ utility software. When
started, the GUP5000™ utility software
program automatically connects to the
device currently connected to the PC.

KP Electronic Systems ATS100 Specifications

General

Brand	KP Electronic Systems
Model	ATS100
Category	Transmitter
Language	English

Summary

ATS100 Programming Guide

Connect ATS100 to GUP5000

Connect ATS100 to PC via RSINT001 adaptor and launch GUP5000 utility software.

Changing Devices

Program various KP devices using GUP5000 utility software, which connects to the current device.

Loading Device Parameter Values

Load Device Parameter Values

Load device parameter values using the GUP5000 utility by clicking Prompt and Read.

Change Device Parameter Values

Type new parameter values in the designated text box for device programming.

Update Parameter Value Changes

Apply parameter value changes by clicking the Program button.

Confirming Parameter Changes

Confirm Parameter Changes

Verify parameter changes by clicking Read on the GUP5000 main screen.

Performing SELF TEST

Perform SELF TEST

Ensure device operation by disconnecting from PC, pressing SELF-TEST, and observing LED.

On-Line HELP

Access On-Line HELP

View parameter explanations and valid ranges by clicking the required parameter text box.