Need help?Do you have a question about the Kracht SPV and is the answer not in the manual?
General| Brand | Kracht |
|---|---|
| Model | SPV |
| Category | Control Unit |
| Language | English |
Describes the installation, operation and maintenance of the pressure relief valves.
Provides the contact details and address of Kracht GmbH.
Details the intended application and operational limits for the pressure relief valve.
Explains safety notices, caution symbols, and signal words used in the manual.
Specifies the necessary qualifications and training for personnel operating the device.
Outlines general safety guidelines and compliance with regulations for safe operation.
Details specific dangers like valve blocking, pin adjustment, and fluid squirting with preventive measures.
Provides a general description of the SPVF pressure relief valve and its function.
Explains the marked flow direction on the device housing from P to R.
Details the basic construction of the SPV/SPVF valve with a component list.
Presents dimensional drawings and specifications for the SPV 10 (EN-GJL-300) series.
Provides dimensional drawings and specifications for the SPV 10 (EN-GJS-400-15) series.
Shows dimensional drawings for SPVF 20-80 series valves.
Provides a table of dimensions and weights for SPVF 20-80 nominal sizes.
Presents dimensional drawings for SPVF 50-80 (EN-GJS-400-15) series.
Contains a table of dimensions and weights for SPVF 50-80 (EN-GJS-400-15).
Lists general characteristics of the pressure relief valves, including construction and materials.
Provides detailed hydraulic specifications like flow capacity, pressure, and temperature ranges.
Details the materials used for various components of the SPV/SPVF.
Presents performance curves showing pressure-flow rate relationships for different valve models.
Instructs on inspecting the device for shipping damage and reporting it.
Details safety warnings and precautions for transporting the device, including lifting and securing.
Explains corrosion protection measures for the device during transport and storage.
Covers safety warnings, including pressure hazards and personnel qualifications for installation.
Provides instructions on checking for transport damage and removing preserving agents before connection.
Emphasizes cleanliness and checks of operating data before starting the device.
Explains how to set and adjust the pressure, and the importance of filling chambers with fluid.
Lists special conditions and restrictions for safe operation, including medium properties and ambient conditions.
Highlights safety aspects for removal, including personnel qualifications and cleanliness.
Details safety warnings related to pressure and hazardous fluids during valve removal.
Stresses the importance of regular maintenance to prevent damages and malfunctions.
Advises examining unusual noises for potential damage indication.
Specifies that dust accumulation is not allowed and regular cleaning is required.
Recommends periodic checks of static seals for leakproofness and replacement if needed.
Advises checking screw joints at regular intervals for tightness and securing them if necessary.
Instructs to check the device and its environment for damage before each shift.
Explains how surface temperature checks can detect wear or overloading.
Defines repairs to include troubleshooting and elimination of damage.
Identifies leaks as frequent problems and suggests tightening screw joints or replacing seals.
Covers onsite repair by replacing devices and manufacturer repairs, with support for spare parts.
Details requirements for returning the device for repair, including packing and safety data sheets.
States that disposal of packaging and used parts must follow local regulations.
Lists common faults like leaks, high opening pressure, and noise, with possible causes and remedies.
To Next Page