ASPEN-32UFX, ASPEN-1616UX, VS-8UFX – Configuring ASPEN-32UFX, ASPEN-1616UX, VS-8UFX
Configuring Genlock Settings
The embedded web pages enable you to configure genlock settings for when you connect a
Genlock source to your device.
To configure genlock settings:
1. Click Genlock.
The Genlock page appears.
Figure 13: Embedded Web Pages – Genlock Page
2. Click Enabled.
Genlock is enabled.
3. In the Resolution drop-down, select the display resolution.
The preset delay for that resolution appears under Delay in micro seconds.
It is recommended to use one of the preset delay times, according to the resolution. If
required you can set a custom delay in the Delay in micro seconds field, and click Set.
Configuring Network Settings
The embedded web pages enable you to configure network settings for your device.
For proper settings and before changing to DHCP, consult your network administrator.
To configure network settings:
1. Click Device Settings.
The Device Settings page appears (Figure 12).
2. In the Ethernet Settings section, change the network settings as required and click Set.
–OR–
If you want the device to obtain a DHCP IP, under DHCP, click ON.
3. Click Set.
To Next Page
Loading...