ASPEN-32UFX, ASPEN-1616UX, VS-8UFX – Protocol 3000
#LOGIN␠login_level,password␍
Get current protocol permission level
Set: ~nn @LOGIN␠login_level,password␠OK␍␊
or
~nn@LOGIN␠ERR␠004␍␊ (if bad password entered)
Get: ~nn@LOGIN␠login_level␍␊
login_level – level of permissions required: User, Admin
password – predefined password (by PASS command). Default password is an empty string
When the permission system is enabled, LOGIN enables running commands with the User or
Administrator permission level.
When set, login must be performed upon each connection.
The permission system works only if security is enabled with the SECUR command. It is not mandatory to
enable the permission system in order to use the device.
Set the protocol permission level to Admin (when the password defined in the PASS command is 33333):
#LOGIN Admin,33333<CR>
Cancel current permission level
Logs out from User or Administrator permission levels
To Next Page
Loading...
Need help?
General
