SID-X1N Quick Start Guide
This guide helps you install and use your SID-X1N for the first time.
Go to www.kramerav.com/downloads/SID-X1N to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
SID-X1N Step-in Commander
1 Power adapter (12V DC output)
We highly recommend using only Kramer UNIKAT cables with these products. If using 3
rd
party shielded CAT-6A cables, both ends of the
shield must be soldered to the connectors for the products to function properly. Do not use any jumpers, unshielded wall plates or mid-
span cable connections. These extenders are not compatible with HDBaseT technologies. Prior to signal extension, ensure that the
extension line cable is lying straight and not coiled.
Step 2: Get to know your SID-X1N
Connect to an unbalanced stereo audio source
Lights green when the HDMI input is selected
Connect to an HDMI source
Lights green when the DisplayPort input is selected
Connect to a DisplayPort source
Lights green when the DVI input is selected
Lights green when the PC-UXGA input is selected
PC-UXGA 15-pin HD
Connector (F)
Connect to a PC graphics source
Press repeatedly to cycle through the inputs manually to select an input, (overrides
automatic selection).
Note: When the button is lit it is inactive and pressing the button will not activate the
input
Press to activate the input on the switcher that the
SID-X1N is connected to
Lights green when the device is powered on
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
To Next Page
Need help?
General
