Kramer Tavor 6-O

Tavor 6-O - Defining the Tavor 6-O
7
7
#
Feature
Function
1
ON/AUTO Switch
Set to AUTO for the speakers to enter the
standby mode when idle for over 10 minutes.
Once a signal is detected the speakers power
up again.
Set to ON to keep the speaker powered
continuously
2
SPEAKER OUT Connectors
Connect the active speaker to the (+) and (-)
stereo sockets on the passive speaker
The L speaker is active and the R speaker is
passive
3
PWR/STBY LED
Illuminates in green when powered (ON/AUTO
switch set to ON or AUTO – see item 1)
illuminates in red when in the standby mode
(ON/AUTO switch is set to AUTO – see item 1)
In the AUTO mode (ON/AUTO switch is set to
AUTO – see item 1), the LED illuminates
green if an input signal is detected and
illuminates red if idle for over 10 minutes
4
INPUT
Connectors
5-pin Terminal Block
Connect the audio source to one or more of the
input connectors
5
L and R RCA
6
3.5mm Mini Jack
7
BASS Control Knob
Rotate the button to control the bass
8
TREBLE Control Knob
Rotate the button to control the treble
9
VOLUME Control knob
Rotate the button to adjust the audio volume
10
AC-Input Power Supply (self-
adjusting)
Connect to the AC power cord
11
POWER Switch
For turning the unit ON (–) or OFF (O)
12
LOOP OUTPUT 3.5mm Mini Jack
Connector
Connect to another pair of active speakers
13
SUB OUT 3.5mm Mini Connector
If required, connect an active sub-woofer to this
output for maximum bass reproduction