Kramer TP-580CT - Quick Start Guide Manual

TP-580CT Quick Start
P/N:
2900- 3014 8 4 QS
Rev:
1
Scan for full manual
TP-580CT Quick Start Guide
This guide helps you install and use your TP-580CT for the first time.
Go to www.kramerav.com/downloads/TP-580CT to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
TP-580CT 4K USB Transmitter
1 Bracket set
1 Quick start guide
1 Power adapter and cord
4 Rubber feet
Step 2: Get to know your TP-580CT
#
Feature
Function
1
USB-C IN Connector
Connect to a USB-C AV source (that supports DisplayPort Alternate Mode). Charges
sources (that support USB Power Delivery 2.0) up to 60W.
While charging, the charging icon (to the right of the connector) becomes visible and
lights orange.
2
IN LED
Lights blue when a USB-C input device is connected.
3
OUT LED
Lights blue when an HDMI output device is detected on the receiver side.
4
LINK LED
Lights green when the HDBT connection is active.
5
ON LED
Lights green when receiving power.
6
HDBT OUT RJ-45 Connector
Connects to the HDBT IN RJ-45 connector on a receiver (for example, TP-580R).
7
RS-232 3-pin Terminal Block
Connector
Connects to a PC/serial controller to control the remote controlled unit (for example, the
display on the receiver).
8
IR 3.5mm Mini Jack
Bidirectional IR connection. Outputs a received IR signal (from the HDBT receiver) to
connected IR emitter or transmits an IR signal (from IR sensor) to the HDBT receiver.
9
SETUP DIP-Switches
Set DIP-switches. By default, DIP-switches are set to OFF (up). Changes in DIP-switch
settings apply immediately.
DIP #
Description
State
1
IR output
modulation
OFF (up) – default
IR pass-through is disabled (38KHz
modulation to IR output signal is added).
ON (down)
IR pass-through is enabled.
2
OFF (up) – default
Normal operation.
ON (down)
FW upgrade via RS-232 is enabled.
10
20V DC
+20V DC 6A connector for powering the unit and charging the connected input device.