Kramer TP-583T Quick Start Guide

TP-583T/TP-583R Quick Start (P/N: 2900-300962QS REV 1)
P/N:
2900- 300962 QS
Rev:
1
Scan for full manual
TP-583T/TP-583R Quick Start Guide
This guide helps you install and use your TP-583T/TP-583R for the first time.
Go to www.kramerav.com/downloads/TP-583T, TP-583R to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check what’s in the box
TP-583T HDMI Line Transmitter or
1 Power adapter and cord
1 Quick start guide
TP-583R HDMI Line Receiver
4 Rubber feet
1 Bracket set
Step 2: Get to know your TP-583T and TP-583R
TP-583T
#
Feature
Function
1
IN LED
Lights green when an active source device input signal is detected.
2
OUT LED
Lights green when an active, far-end sink (acceptor) connection is
detected via the HDBT link.
3
LINK LED
Lights green when an HDBT link is established with the HDBaseT
receiver.
4
ON LED
Lights green when the device receives power.
5
LINE RJ-45 Connector
Connect to the RJ-45 HDBT LINE connector on a receiver (for
example, TP-583R, TP-780R and so on).
6
HDMI™ IN Connector
Connect to an HDMI source.
7
SETUP DIP-switches
Set the operation DIP-switches.
8
RS-232 (G, Rx, Tx) 3-pin Terminal Block Connector
Connect to a laptop to control the receiver or perform firmware
upgrade.
Connect to a controller device (for example, SL-240C) to serially
control a remote device (for example, the HDMI OUT acceptor) that
is connected to TP-583R.
9
IR 3.5mm Mini Jack Connector
Connect to an external infrared emitter / sensor.
10
12V DC Power Connector
12V DC connector for powering the unit.

Kramer TP-583T Specifications

General

Brand	Kramer
Model	TP-583T
Category	Transmitter
Language	English