Kramer TP-590TXR Quick Start Guide

TP-590TXR Quick Start (P/N: 2900-300864QS REV 2)
P/N:
2900- 30086 4 QS
Rev:
2
Scan for full manual
TP-590TXR Quick Start Guide
This guide helps you install and use your TP-590TXR for the first time.
Go to www.kramerav.com/downloads/TP-590TXR to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
TP-590TXR HDMI Line Transmitter
4 Rubber feet
1 Bracket set
1 Power supply (48V DC)
1 Quick start guide
Step 2: Get to know your TP-590TXR
#
Feature
Function
1
USB Connector
Connect to the USB host, (for example, a laptop).
2
POE STATUS LED
Lights green when power is supplied over the HDBT link.
3
LINK LED
Lights green when the HDBT link is valid.
4
IN LED
Lights green when an HDMI active signal device is connected.
5
ON LED
Lights green when the device receives power.
#
Feature
Function
1
HDMI IN Connector
Connect to the HDMI source.
2
IR 3.5mm Mini Jack Connector
Connect to an external infrared transmitter or sensor.
3
RS-232 3-pin Terminal Block
Connect to an RS-232 controller, (for example, a PC to control the projector).
4
AUDIO IN 3.5mm Mini Jack
Connect to the stereo, analog audio source.
5
HDBT OUT RJ-45 Connector
Connect to the HDBT IN RJ-45 connector on the HDBT receiver.
6
SETUP 4-way DIP-switch
Sets the device behavior (see Step 4).
7
CONTROL
RS-232 3-pin
Terminal Block
Connect to the serial controller to control this device.
8
ETHERNET
RJ-45 Connector
Connect to the Ethernet controller to control this device or to a LAN to transfer network traffic.
9
RESET Switch
Press and hold for 5 seconds to reset the device to factory default settings.
Press and immediately release to power-cycle the device (Reset).
10
PROG Mini USB Connector
Connect to a PC to perform firmware upgrades.
11
48V DC Power Connector
Connect to the power supply.

Kramer TP-590TXR Specifications

General

Brand	Kramer
Model	TP-590TXR
Category	Transmitter
Language	English