Kramer VIA GO2 Quick Start Guide

Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your VIA GO2. For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to VIA GO2. Using third-party cables may cause
damage!
1. Connect the keyboard
and mouse.
2. Connect an HDMI
display.
3. Connect to the LAN
(default mode).
If you wish to use a
Kramer active optical
pluggable HDMI
cable with your VIA
GO2, contact your
local Kramer office to
assist in purchasing
the correct cable.
Step 5: Connect the power
Connect the 12V DC power adapter to VIA GO2 and plug it into the mains electricity.
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the Kramer Electronics power adapter that is provided with the unit.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
See www.KramerAV.com for updated safety information.
Step 6: Configure VIA GO2
A wizard guides you through configuration. If you choose to skip the wizard, follow these steps for configuration:
General Settings Configuration
1. On the Kramer VIA dashboard, click Features > Settings.
The settings login window appears.
2. Enter the User Name (default = su) and Password (default = supass) and
click Login.
The VIA Settings window appears.
The VIA Settings tabs are:
▪ LAN Settings – Configure network parameters (default = DHCP)
▪ System Controls – Manage your display and audio settings, set
the time, select your language, etc.
▪ Wi-Fi – Activate and configure the built-in Wi-Fi capability.
3. When you have finished configuring settings, click Reboot to apply all settings.
Change to AP Wi-Fi Mode
Set up the built-in Wi-Fi module as a secondary Access Point (for guests).
1. On the Wifi tab, click the switch next to Switch On or Off Wifi. The switch turns green and additional Wi-Fi settings appear.
2. Click AP Mode, and enter a new name in the SSID field and a new password or use the default name and password.
3. Select a Wi-Fi channel for the Access Point.
4. Select Enable Internet (if the primary LAN network is connected to the Internet) OR Activate Standalone Wifi (to create an
autonomous network without Internet access) and click Apply.
Switch to Client Wi-Fi Mode
Attach your VIA GO2 as a client device to your main network:
1. On the Wifi tab, click the switch next to Switch On or Off Wifi. The switch turns green and additional Wi-Fi settings appear.
2. Click Client Mode, select an available network from the drop-down.
3. Enter the required password and click Apply.
4. Disconnect the LAN cable (if connected) before rebooting the device.
Eth
KeyboardKeyboard Mouse
USB
USB
Display
HDMI
LAN

Kramer VIA GO2 Specifications

General

Brand	Kramer
Model	VIA GO2
Category	Conference System
Language	English