Kramer VM-2UHD

VM-2UHD Quick Start
P/N:
2900- 301083 QS
Rev:
2
Scan for full manual
VM-2UHD Quick Start Guide
This guide helps you install and use your VM-2UHD for the first time.
Go to www.kramerav.com/downloads/VM-2UHD to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VM-2UHD 1:2 HDMI DA
4 Rubber feet
1 Bracket set
1 Power cord and adapter
1 Quick start guide
Step 2: Get to know your VM-2UHD
#
Feature
Function
1
PROGRAM Mini USB Connector
Connect to a PC to perform firmware upgrades (via K-Upload) and work with the EDID
Designer.
K-Upload and EDID Designer can be downloaded from our Web site at:
www.kramerav.com/downloads/VM-2UHD).
To use the mini USB port, you need to download and the Kramer USB driver from our
Web site at: www.kramerav.com/support/product_downloads.asp and install it.
2
EDID SETUP Button
Press to capture the input EDID, select the default EDID or activate Force RGB.
3
IN LED
Lights when an active input signal is detected.
4
OUT LEDS (1 to 2)
Lights when an active output acceptor is detected.
Flashes when a non-HDCP acceptor is connected to the output and the input is
HDCP-encrypted (the content is displayed for only a few seconds).
5
ON LED
Lights when the device is powered on.
6
HDMI™ IN Connector
Connects to the HDMI source.
7
HDMI OUT Connectors (1 to 2)
Connect to up to 3 HDMI acceptors.
8
5V DC Connector
Connects to the 5V DC power supply.