Install VM-2UHD using one of the following methods:
• Attach the rubber feet and place the unit on a flat surface.
• Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to
www.kramerav.com/downloads/VM-2UHD.
• Mount the unit in a rack using the recommended rack adapter
(see www.kramerav.com/product/VM-2UHD).
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your VM-2UHD. For best results, we recommend that
you always use Kramer high-performance cables to connect AV equipment to VM-2UHD.
Step 5: Connect the power
Connect the 5V DC power adapter to VM-2UHD and plug it into the mains electricity.
Safety Instructions
There are no operator serviceable parts inside the unit.
Use only the Kramer Electronics power supply that is provided with the unit.
Disconnect the power and unplug the unit from the wall before installing.
See www.KramerAV.com for updated safety information.
To Next Page
Loading...