Kramer VM-8UX - Connecting the VM-8 UX

To Next Page

To Previous Page

VM-8UX – Connecting the VM-8UX

4 Connecting the VM-8UX

Always switch off the power to each device before connecting it to

your VM-8UX. After connecting your VM-8UX, connect its power and

then switch on the power to each device.

You do not have to connect all the inputs and outputs, connect only

those that are required.

1. Connect an SDI video source (for example, a 12G SDI camera) to the

INPUT BNC connector.

2. Connect up to eight video OUT BNC connectors to the appropriate HD-SDI

video acceptors (for example, 12G SDI displays).

For best results, when only one of the paired outputs (OUT 1 + OUT 2, OUT 3 + OUT 4,

OUT 5 + OUT 6 and OUT 7 + OUT 8) is connected, cover its pair connector with a 75Ω

terminator (supplied).

For example, if only OUT 3 is connected, cover OUT 4 with a terminator (the other

outputs do not need to be covered).

3. Connect the 5V DC power adapter to the power socket and connect the

adapter to the mains electricity (not shown in Figure 2).

Figure 2: Connecting to the VM-8UX