11 Connecting the VP-5T/VP-5THD and the VP-5R
You can use the VP-5T/VP-5THD 1:4 VGA/UXGA Distributor / CAT 5
Transmitter and the VP-5R
CAT 5 Receiver / 1:5 VGA/UXGA Distributor to
configure an XGA Line-to-Twisted Pair Transmitter and Receiver system.
To connect the VP-5T/VP-5THD with the VP-5R, as the example in
Figure 12 illustrates, do the following:
1. On the VP-5T/VP-5THD , connect the computer graphics source (for
example, a computer) to the INPUT 15-pin HD connector, and connect
up to
1
4 acceptors (for example, local displays) to the OUTPUT 15-pin
HD connectors 1 to 4.
2. On the VP-5R, connect up to
1
5 acceptors (for example, displays) to the
OUTPUT 15-pin HD connectors 1 to 5.
3. Connect the CAT 5 OUT RJ-45 connector on the VP-5T/VP-5THD to the
CAT 5 LINE IN RJ-45 connector on the VP-5R, via UTP cabling (with a
range of more than 300ft (more than 100m)), see section 11.1.
4. Connect the power cord
2
(not illustrated in Figure 12) to the
VP-5T/VP-5THD , and connect the other power cord
2
to the VP-5R.
5. On the VP-5T, if required:
Adjust
3
the front panel cable ompensation equalization
level
Set the underside ID BIT Control switches
6. On the VP-5THD, if required:
Set the H SYNC and V SYNC switches
4
on the underside
7. On the VP-5R, if required:
Adjust
3
the front panel LINE INPUT signal level and/or
cable compensation equalization level, and/or OUTPUT
compensation equalization level
Set the V SYNC and H SYNC switches
4
, on the underside
1 When not all the outputs are required, connect only those that are required and leave the other output(s) unconnected
2 We recommend that you use only the power cord that is supplied with each specific machine
3 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
4 By default, both switches are set down (for negative V SYNC and H SYNC polarity)
To Next Page
Loading...
