Kramer VW-16

#
Feature
Function
6
RCL Button
Press, followed by an Input button (1 to 4), to recall a pre-saved wall configuration.
7
IDENTIFY Button
When pressed, will identify each window by displaying A, B, C or D in it.
8
MENU Button
Displays the OSD menu.
9
Navigation
Buttons

Press to decrease numerical values or select from several definitions.
When not in the OSD menu, press to reduce the output volume.

Press to move up the menu list values.

Press to increase numerical values or select from several definitions.
When not in the OSD menu, press to increase the output volume.

Press to move down the menu list.
ENTER
Press to accept changes and change the SETUP parameters.
10
RESET TO 1080p Button
Press and hold for about 5 seconds to set the output resolutions to 1080p.
11
PANEL LOCK Button
Press and hold to toggle locking and unlocking the front panel buttons.
12
ON LED
Lights green when power is on, and flashes when scaling is not working properly.
13
STATUS LED
Lights green when fan operates properly. Flashes in case of fan malfunction.
#
Feature
Function
14
SERVICE USB Port
Connect a USB flash drive to perform firmware upgrade.
15
RS-232 9-pin D-sub Serial Port Connector
Connect to a PC/serial controller
16
ETHERNET RJ-45 Connector
Connect to a PC or other serial controller via a LAN.
17
5-pin Terminal
Block Connector
RS-422 (Tx+, Tx-, G, Rx+, Rx-)
Connect to a PC/serial controller.
RS-485 (G, A, B)
Connect to a PC/serial controller.
18
AUDIO OUTPUT 3-pin Terminal Block Connector
(L, G, R)
Connect to an unbalanced stereo audio acceptor (for example,
powered speakers).
19
INPUT HDMI Connectors (1 to 4)
Connect to up to 4 HDMI sources.
20
OUTPUT HDMI Connectors (1 to 16)
Connect to 16 HDMI displays.
21
Grounding Opening
Use a M3 screw to lock the ground wire and connect to ground.
22
Mains Power Connector and Power Switch
Plug in the power cord and use the switch to power the unit on or off.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Step 3: Mount VW-16
To rack mount the machine, attach both
rack ears (by removing the screws from
each side of the machine and replacing
those screws through the rack ears) or
place the machine on a table.
• Ensure that the environment (e.g., maximum ambient
temperature & air flow) is compatible for the device.
• Avoid uneven mechanical loading.
• Appropriate consideration of equipment nameplate
ratings should be used for avoiding overloading of the
circuits.
• Reliable earthing of rack-mounted equipment should be
maintained.