Kramer WP-789T Quick Start Guide

TP-789Rxr Quick Start (P/N: 2900-301008QS REV 1)
P/N:
2900- 301008 QS
Rev:
1
Scan for full manual
TP-789Rxr Quick Start Guide
This guide helps you install and use your TP-789Rxr for the first time.
Go to www.kramerav.com/downloads/TP-789Rxr to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
TP-789Rxr HDMI Line Receiver
4 Rubber feet
1 Quick start guide
1 Power adapter and cord
1 Bracket set
Step 2: Get to know your TP-789Rxr
#
Feature
Function
1
SETUP DIP-switches
Set the operation DIP-switches.
2
IN LED
Lights green when an active, far-end source device input signal is
detected.
3
OUT LED
Lights green when an active sink (acceptor) output signal is detected
via the HDBT link.
4
LINK LED
Lights green when an HDBT link is established with the HDBT
transmitter.
5
POE FEEDER LED
Lights green when the device is feeding PoE power to the HDBT
connected transmitter.
6
ON LED
Lights green when the device receives power either from the power
supply unit or by PoE.
7
HDBT IN RJ-45 Connector
Connect to the RJ-45 HDBT OUT connector on a transmitter (for
example, WP-20, TP-780Txr).
8
HDMI OUT Connector
Connect to an HDMI acceptor.
9
ETHERNET RJ-45 Connector
For LAN extension to the transmitter.
10
IR 3.5mm Mini Jack Connector
Connect to an external infrared emitter / sensor.
11
RS-232 (G, Rx, Tx) 3-pin Terminal Block Connector
Connects to an RS-232 port for serial link extension to a transmitter.
12
48V DC Power Terminal Block Connector
If TP-789Rxr provides PoE, connect it to the Kramer power supply.
If it accepts PoE, no power connection is needed.

Kramer WP-789T Specifications

General

Brand	Kramer
Model	WP-789T
Category	Extender
Language	English