Need help?Do you have a question about the Kreepy krauly VTX-7 and is the answer not in the manual?
General| Pool Type | In-ground |
|---|---|
| Warranty | 2 Years |
| Type | Automatic Suction Pool Cleaner |
| Cleaning Coverage | Floor and Wall |
| Suitable for Pool Types | Concrete, Fibreglass, Tile, Vinyl |
| Drive System | Vortex Action |
Gently run the straps of the scoop around the groove in the main body. Ensure tabs overlap when secured.
Slide the seal onto the groove at the bottom of the main assembly body so it rotates freely.
Fit the sole to the base of the main body, ensuring it is fitted all the way around.
Fit the steering adjuster float bar into the top bridge of the dive float assembly.
Ensure the pool is clean, balanced, algae-free, and the pump is turned off.
Connect the Smart-Skim or Auto Skim valve to the vacuum plate using the correct adaptor.
Connect hose lengths to create a hose long enough for pool coverage plus extra.
Slide hose weights along the hose at specified distances to optimize VTX-7 performance.
Submerge the assembled hose in the pool to expel all air by pushing downwards.
Submerge the VTX-7 to expel air, then connect the weighted hose end to the swivel head assembly.
Connect the hose to the Smart-Skim or Auto Skim valve using a retaining collar and protector sleeve.
Adjust hose weights to achieve a 45° incline for optimal VTX-7 performance.
Use the Steering Adjuster Float Bar or Extended Float Bar to customize the VTX-7's turning circle.
Addresses VTX-7 not moving, moving slowly, or not pulsating, checking sole, valves, and blockages.
Addresses low vacuum or slow, faltering hammering sounds by checking debris, valve seating, and filter.
Solutions for VTX-7 staying at one end or traveling only around the water line.
Fixes for VTX-7 wedging on steps, not reaching 45°, climbing partially, or getting stuck on drains.
Addresses VTX-7 traveling in one direction or sticking on underwater lights by checking alignment.
Fixes for bubbles at outlets or VTX-7 surfacing due to air, checking hose, pump, valves, and steering.
Explains the VTX-7's backward movement using water flow and drive tubes, generating a ticking sound.
Describes steering via the dive float assembly, creating a crisscross pattern for pool coverage.
Details cleaning action: skimming, scrubbing, vacuuming debris to the skimmer and filter.
Explains the Ultra Flex hose's buoyancy and function, allowing free movement for complete pool coverage.
Details warranty protection: use genuine parts, proper chlorination, and avoid non-genuine parts.
Instructions on activating the warranty by filling out details or via the online portal.
Advice on removing VTX-7 during shock treatment, chemical use, and checking seals.
Guidelines for hose care: avoid stretching, lifting, hanging, and proper storage methods.
Steps to check and clean the flow valve, including removing parts and clearing debris.
Warning about pool blankets affecting chlorine levels and potentially voiding the warranty.
To Next Page
